CNC 4-Axis Complete Kit 270 Oz-in Nema23 Motor & TB6560 Driver f

Description:

This is SainSmart new CNC complete kit for engraving DIY. It comes with necessary and basic parts to make your own engraving machine. It is simple and easy to assemble the parts.

Specification:

• 5 axis breakout board

1.Support of MACH3 and other computer software support for parallel port control.
2.Leads to all the parallel port 12 data transmission output pin, which can control the five stepper motor driver;
3.With 5-way input interface, can take the limit switch and emergency stop switch, home switch and prove switch;
4. 5 input LED indicates the status of the input;
5.With the way 12A relay control, normally open, normally closed leads, user-friendly connection;
6.Supply 5V USB power supply or external power supply to facilitate the access of external power supply;
7.On the external drive enable signal amplification, filtering, enhancement processing;
8.Pulse, the direction of signal shaping, enhanced load capacity, data transmission speeds reach 10 MBit / S;
9.Output pins with the expansion interface can 2.54mm pin 2.54mmXH-Block;

• TB6560 Stepper Motor Driver

1.the use of new imported Japanese Toshiba TB6560 chip;
2.The base used dense teeth radiator, cooling super, to ensure the stable operation of equipment;
3.the input signal using a high-speed opto-isolation to ensure not losing steps, which the pulse direction signals with the same level of 6N137, dual high-speed optocoupler;

4. A variety of semi-flow mode and the semi-flow current selection, the use of more flexible
5.Decay mode is adjustable to ensure the motor running smooth;
6.Compact Dimensions, cooling pad size: 75mm * 65mm, four mechanical installation positioning hole size is: 67mm * 58, mounting hole diameter is 4mm
7.Set method detailed table on the board, easy to use;
8.With anti-reverse circuit, even if not careful the power plug back and will not burn the chip, it's very safe to use.

• Stepper motor

• Switching power supply

1. the range of AC input voltage is changed by the switch
2. high-efficiency, high reliability
3. 100% full load burn-in test
4. Protections: Short circuit / overload / over voltage / over temperature
5. built-in cooling DC fan control
6. Working frequency is 25 kHz
7. Input Voltage:220V/115V
8. Output Voltage:24V
9. Output Current:10A
10. Output Power:250W

Package List:

• 1 x 24V/10A switching power supply
• 4 x 1 Axis TB6560  stepper motor driver
• 4 x 57HS76  3A 270 oz/in  stepper motor
• 1 x 5 axis breakout board
• 1 x DB25 parallel cable
• 1 x USB cable
• 4 x signal cables
• 1 x CD